Can a bad speaker wire damage a receiver?
Can a bad speaker wire damage a receiver?
Bad speaker wires can damage your receiver Speaker wires may be the most common culprit to damaged speakers, receivers and amps. Consumers were convinced they need 10AWG -12AWG monster speaker wires to get good sound. If the wire is not trimmed properly and has whiskers it can short output transistors.
Why does my nad 2600A AMP cut out?
Just in the past two weeks my NAD 2600A amp’s right channel started to cut out. WTF? now both channels are cutting out.. I looked online for repair service. and came upon this as a possible problem that is common with this model of older NAD amps.
Are there any problems with Onkyo TX sv7m speaker wire?
The biggest problem with large gauge wire is you can’t fit to the connectors on receiver or speakers wires touch each other and it not possible to make good connections. Onkyo TX-SV7M Power output was specified at 90 watts per channel for the front left and right channels and have 28 to 24 gauge internal speaker connection wires.
Bad speaker wires can damage your receiver Speaker wires may be the most common culprit to damaged speakers, receivers and amps. Consumers were convinced they need 10AWG -12AWG monster speaker wires to get good sound. If the wire is not trimmed properly and has whiskers it can short output transistors.
Why does my AV receiver keep turning off?
Sounds like an issue with the receiver. If it’s still under warranty tell them that it turns off when it receives a surround signal with the surround speakers disconnected. If your input is HDMI you can try a using a digital input instead for audio and see it the problem still occurs.
Just in the past two weeks my NAD 2600A amp’s right channel started to cut out. WTF? now both channels are cutting out.. I looked online for repair service. and came upon this as a possible problem that is common with this model of older NAD amps.
What to do if your Onkyo speaker goes into Protect Mode?
If the receiver shuts off and goes back into protect mode you will need to contact your Onkyo dealer. Turn the volume back to the minimum setting and turn off the receiver. Unplug the power cord from the wall and then reconnect the speaker and audio cables. Plug the power cord back in and then power then turn on the receiver.
