How to reset Marantz sr5003 to protect mode?

To reset: power ON; press and hold the SURROUND MODE and the CLEAR buttons for 3 seconds or more. Should none of the above be corrective, then it would most likely be an internal hardware fault. Options then are:

Why does my Marantz speaker have a flashing standby light?

It now simply has a flashing standby light (approx 2 times a second) when I turn the power on. In the manual it says to disconnect all the speakers etc to see if it is a blown speaker or a short circuited speaker that is the cause. All speakers are disconnected – with only the power supply attached and it is still the same.

How many times does the Marantz power cord Blink?

The Marantz Manual troubleshooting states that the In some cases, the “STANDBY indicator may blink slowly, twice per second.” & also “In rare instances, the unit may enter standby mode and the STANDBY indicator may blink rapidly, 8 times per second. In this case, unplug the power cord and request service at your nearest service center.”

Why is my Marantz sr7001 flashing red standby?

I have a marantz sr7001 and Was watching a movie and it went into stand by. Light flashes quickly and will other power on. I tried the reset procedures of holding 7.1, pure audio and clear.

How often does a Marantz sr5003 go into standby mode?

In some cases, the “STANDBY indicator may blink slowly, twice per second.” & also “In rare instances, the unit may enter standby mode and the STANDBY indicator may blink rapidly, 8 times per second. In this case, unplug the power cord and request service at your nearest service center.”

Why does my Marantz power supply stop working?

If you are lucky this will just stop at the caps, and the unit will function again after replacement. If you are not used to this be careful as power supply caps hold dangerous voltages after power is removed.

How to reset Marantz sr5003 to protect mode?